There’s nothing inherent in a charger that makes it suitable only for motorcycles or cars, although you’ll have to be careful with using a ‘car’ charger on a motorcycle battery to insure the motorcycle battery doesn’t get charged too fast and that the charger used is suitable for the battery type.
Can you charge a motorcycle battery with a car battery?
Yes, you can charge a motorcycle battery with your car but, it will charge too much/ too fast, too many AMPS. Don’t do it for more than a couple of minutes. Much better to use a battery charger even at 2 AMPS.
What type of battery charger do I need for a motorcycle?
Use either a trickle, float, or smart charger for most battery types. These chargers work best on lead acid, gel, or absorbed glass mat batteries. Do not use these chargers with lithium batteries. Trickle, or fully manual, chargers are the easiest type to use.
Can you start a motorcycle with a battery charger?
It’s no problem jump starting a motorcycle from a car or another motorcycle. … A common myth is that you can damage the charging system of a bike by jump starting it. Even if you do it from a running car, it’s 14.2 V as opposed to 12.8 V of a fully charged battery, the jump start won’t damage the bikes charging system.
How long do you need to ride a motorcycle to charge the battery?
Riding for only twenty minutes isn’t enough to get it charged either. Put the bike on a charger overnight, and then use a battery tender when you’re not riding to keep it charged.
What amp should I charge my motorcycle battery at?
When charging a motorcycle or other small battery, the battery charger should not exceed 3 amps. Most automotive types of battery chargers are not suitable due to higher current output. While maintaining a battery at its full state-of charge will ensure optimum life, overcharging may significantly reduce it.
Can a completely dead motorcycle battery be recharged?
If you do have a dead battery, you can recharge it with a battery charger (this is preferred), or by jumpstarting your bike with another bike or a car. … Once you get the bike running, make sure to ride it for a good while in order to get it fully charged again.
How long does it take to charge a 12v motorcycle battery?
At least 6 hours and up to 24 hours. A brand new lead acid, 12 volt battery under a constant-current charge, will take 5 – 8 hours to charge up to 70%. The remaining 30% will require another 7 – 10 hours before it is ready to install on the motorcycle.
How long can I leave a trickle charger on my motorcycle battery?
So 16 hours is the maximum safe time that the battery should be on that charger. The longer it is left on the hotter the battery will get and over time it will boil the battery dry.
Is it better to charge a battery at 2 amps or 10 amps?
It is best to slow charge the battery. Slow charging rates vary depending on the battery’s type and capacity. However, when charging an automotive battery, 10 amps or less is considered a slow charge, while 20 amps or above is generally considered a fast charge.
Can you leave a trickle charger on all the time?
Trickle chargers are low-amp chargers that top up a drained battery to keep it at its maximum capacity. … It can be left on indefinitely, charging a car if you only use it once in a few months, and it will ensure that the battery never goes flat.
Why do motorcycle batteries die so fast?
All too often, motorcycle batteries die young, murdered by neglect. Dehydration, improper charging, and a slow discharge during storage all shorten a battery’s life. … To prevent these draws from killing your battery, you could disconnect the battery, but even if there is no load on them, batteries self-discharge.
Can you charge a dead motorcycle battery with a trickle charger?
The best and safest way to charge modern batteries is by getting a smart charger that can monitor your battery’s charge and stop itself before it overcharges the cells. A trickle charger is also relatively safe, but it takes a long time to work. … Even then, you don’t want to leave it on the charger longer than you must.
How do you start a motorcycle with a dead battery?
How to Push Start a Motorcycle with a Dead Battery
- Insert your key and turn the ignition on (make sure the engine kill switch is also on).
- Put the bike into second gear, this will help prevent the bike from jerking when it starts.
- You will need to get the bike moving to at least 5MPH or 8KMH so pull in the clutch while seated on the bike and have your friends push.
10 июл. 2014 г.
How do I know if my motorcycle battery is bad?
If your kickstand is up, and the bike won’t fire, this switch may be faulty. Consider, too, that if your headlight comes on and is typically bright, and your horn sounds normal, a dead battery is unlikely. Telltale signs that the problem is the battery include weak or nonfunctioning lights and horn.