Frequent question: What can I use to clean my motorcycle chain?

To clean, some folks swear by kerosene, some WD-40. Some riders use a dedicated branded chain cleaner. Some use a grunge brush and some simply spray the chain down. As far as lubrication goes, some prefer a drier wax lube, some prefer to use the sticky blue stuff, and yet others use gear oil in a squirt bottle.

What is the best motorcycle chain cleaner?

The best motorcycle chain cleaners

  • Muc-Off Biodegradable Chain Cleaner — $16.49 for a 16.9-ounce can. …
  • Maxima Clean Up Chain Cleaner — $9.95 for a 17.1-ounce can. …
  • Motul Chain Clean — $10.41 for a 9.8-ounce can. …
  • Everyday, more affordable alternatives. …
  • The Grunge Brush, $14.95/$20.95. …
  • Tirox 360 Brush, $12.95.

Can I use WD40 to clean my motorcycle chain?

It is highly recommended that you do not use Multi-Purpose WD-40 on your motorcycle chain. The WD stands for Water Displacement, and it is designed to disperse water away from metal parts to prevent rust.

IT IS INTERESTING:  Quick Answer: Is it hard to finance a motorcycle?

Can I use brake cleaner to clean my motorcycle chain?

Just used an old spray can of brake cleaner I found in the garage on my chain. Amazing results – chain clean and free of grease after one application. Just left it on a bit of card until the fluid had evaporated and gave it a quick wipe down.

Is it OK to clean motorcycle chain with kerosene?

While you can opt for something like Maxima Clean Up Chain Cleaner, kerosene will also work equally as well to dissolve the existing lubricant and dirt particles on the chain. As you work your way around the chain, don’t be shy about really soaking things down. Kerosene is cheap, new motorcycle chains are not.

How often should you clean motorcycle chain?

As a general rule of thumb, it’s best to clean and lubricate a motorcycle chain with O-rings at least every 600 miles, while plain chains require more frequent attention.

Why is WD40 bad for bike chains?

WD40 is primarily a solvent, which means that it dissolves contaminates so parts get nice and clean. As a solvent, WD-40 will strip away any existing lubricant, leaving your chain, and drivetrain dryer than before application. This means that using WD-40 as a chain lubricant is worse than using no lube at all.

How long should a motorcycle chain last?

But chains wear out over time and need replacing. So, how often should a motorcycle chain be replaced? In general, a properly maintained motorcycle can will last 20,000 to 30,000 miles, sometimes more. But, some last as little as 5,000 to 10,000 miles.

IT IS INTERESTING:  How do you wear rain gear on a motorcycle?

Can I use degreaser on motorcycle chain?

I’ve heard of people using all kinds of different degreasers, from engine degreasers to oven cleaners. I’ve been using it for years to clean all my motorcycle and bicycle chains. Safe for all bicycle chains and all motorcycle standard roller, o-ring and x-ring chains.

Can you clean a motorcycle chain with soap and water?

You can use hot water with dish soap, a solvent or a degreaser. Step 2 Place the removed bicycle chain into the pan or plastic tub. Soak the chain for one to two minutes. Step 3 Remove the chain from the cleaning solution.

When should you clean and lube a motorcycle chain?

A motorcycle chain should be lubricated every 300-600 miles to ensure peak performance and a long life. Lubricate the chain after riding, not before. This allows time for the solvents in the spray to evaporate before the bike is used again, and lets the lubricant penetrate the link properly.

Can I clean my bike chain with water?

Rinse off the cassette, chain, chainrings, and derailleur pulleys with a low-pressure stream of water. Avoid squirting water directly into any bearings. Dry everything with a clean rag, and then set the bike aside to air dry further. Alternatively, use compressed air to speed up the process.

What should you not use brake cleaner on?

In order to prevent ruining certain surfaces, avoid using brake cleaner on plastics, rubber, and any painted surface that you want to maintain. Protect these surfaces with careful application and small amounts of product at one time.

IT IS INTERESTING:  When should motorcycle shocks be replaced?

Can you clean a motorcycle chain with paraffin?

I’ve been using paraffin (from B&Q) for over a year now, works better than any ‘proper’ chain cleaner and no adverse effects. Also if you’re a hardcore skinflint like me you can keep any mucky paraffin left over, the crap settles to the bottom of the bottle eventually, then you can re-use it.

Will brake cleaner damage O rings?

It’s not only that brake cleaner may damage the O-rings….it can get past them and disolve the lubricant which will then be slung back past the seals in solution with the cleaner, thereby shortening the chain life.

Types of transport