What does the key symbol mean on a Harley Davidson?

If the security light (the key) stays on solid (not flashing) and the bike starts and runs, it means the bike has thrown a DTC.

What does the key light mean on my Harley?

The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed. Apr 26, 2009.

How do you start a Harley without a key fob?

STARTING YOUR HARLEY-DAVIDSON WITHOUT YOUR FOB!

Immediately hold both turn signal indicators until FIVE dashes appear in the odometer gauge. Select the first digit of your PIN (a) by pressing the left turn signal button (a) times. Press the right turn signal switch one time to move to the next digit.

How do I reset my Harley-Davidson security system?

Try this: Turn the key to ignition and immediately hold both switches in until your code appears. Do not change your code. The first number should be flashing. Press the right turn switch once for each number until you get to the last number flashing.

IT IS INTERESTING:  Question: Can you change the color of a motorcycle?

What is a TSM on a Harley?

The factory security system is contained within the Turn Signal Module (TSM), which becomes a Turn Signal Security Module (TSSM) when it is so equipped.

How does the Harley security system work?

When the motorcycle is parked and the ignition key is turned to OFF, the Harley-Davidson® Smart Security System arms automatically within five seconds if no motion is detected. Upon arming, the turn signals will flash twice and the optional siren will chirp twice.

What do I do if I lost my Harley Davidson key?

A locksmith can use your bike’s ignition cylinder code or the entire ignition cylinder to make a new key. You also have the option of reordering a key from a local dealer, using your bike’s VIN. A traditional motorcycle key is the easiest key to replace.

How much does a Harley Davidson key fob cost?

The average cost for a replacement key made by vin is $50 and can be done by most if not all local authorized Harley Dealer.

Can you reprogram a Harley key fob?

As long as you have the key, you can do the remote’s programming on your own. It involves a combination of setting the ignition bezel back and forth in the correct positions, pressing the turn signals and pushing the remote’s buttons at the right time.

How do you reset the pin on a Harley 2020?

  1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window.
  2. Enter the first digit of your PIN by pressing the LEFT turn signal switch (X) times.
  3. Press the RIGHT turn signal switch 1 time to move to the next digit.
IT IS INTERESTING:  How much does it cost to powder coat a motorcycle?

How do you disable a security system?

You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.

Where is the turn signal module on a Harley?

Behind the splash guard in front of the rear wheel.

How do I test my Harley Davidson TSM?

To diagnose the TSM/TSSM observe the behavior of the turn signals.

  1. Set Run switch to Run – –
  2. Turn Ignition key On-Off-On-Off-On-Off-On and then toggle the Left Turn Signal switch twice. – –
  3. Turn Ignition key Off-On Verify the Check Engine lamp and Security Lamp illuminate briefly and then turn off.
Types of transport