What is the Harley Davidson Security option?

When the motorcycle is parked and the ignition key is turned to OFF, the Harley-Davidson® Smart Security System arms automatically within five seconds if no motion is detected. Upon arming, the turn signals will flash twice and the optional siren will chirp twice.

How do you use a Harley-Davidson alarm?

Select the fifth digit of your PIN (e) by pressing the left turn signal switch (e) times. Press the right turn signal indicator one time to advance to the next digit. Press the right turn signal indicator once. The security system alarm is now off.

Why is my Harley Davidson asking for a PIN?

If you have a security-equipped Harley-Davidson, you know that without your key fob present, the bike will not start. What you should also know is your PIN number, just in case you lose your key fob mid-ride. … Press and hold the left turn signal until you see “Enter PIN” flash on the speedometer.

How do you disable a security system?

You can turn off or power down your home alarm system by disconnecting its backup battery and then unplugging the transformer for the device from the wall outlet. You can confirm that the panel has been powered down by checking its touchscreen or keypad and making sure that it is blank.

IT IS INTERESTING:  Frequent question: Where do I find my motorcycle chassis number?

How does the Harley security system work?

When the motorcycle is parked and the ignition key is turned to OFF, the Harley-Davidson® Smart Security System arms automatically within five seconds if no motion is detected. Upon arming, the turn signals will flash twice and the optional siren will chirp twice.

How do I disconnect my Harley battery without alarm?

Re: How to remove the battery without alarm going off? Have the Fob near the bike and turn on the ignition then turn it off. This should reset the alarm.

How do I get my Harley out of transport mode?

When the vehicle is in the transport mode, the security system does not respond to motion detection. To exit the transport mode, use the key fob to disarm the vehicle.

How do you unlock a Harley Davidson security system?

your best bet would be to go up to the store and pick up a 2032 watch battery and replace it in your fob. at this time, your present code will be flashing in the odometer, to change it, you cycle the digit with the left turn signal, and enter with the right. after you change all 5 numbers, you’re done.

How do you reset the security code on a Harley Davidson?

  1. Turn the IGN key to IGNITION and immediately hold both turn signal switches until 5 dashes appear in the odometer window.
  2. Enter the first digit of your PIN by pressing the LEFT turn signal switch (X) times.
  3. Press the RIGHT turn signal switch 1 time to move to the next digit.
IT IS INTERESTING:  Are Timberland boots good for motorcycle riding?

What is the red key light on my Harley?

The red “key” light is telling you that the security system is operational. The fact that it goes out after you start it up means that the security system is disarmed.

How do you tie down a motorcycle on a trailer without chock?

Use soft straps on the bike itself, then loop each of those to a ratchet strap. Compress your shocks a little, so the straps won’t disengage if you hit a bump in the road. Choose your anchor points carefully; two at the front, two at the back, one to a side. Don’t leave any slack in the straps.

Types of transport